GESTIONVAL ODNODN INFRASTRUCTURE Technical Inquiry
HOME / How to connect a Layer 3 switch to a gateway

How to connect a Layer 3 switch to a gateway

Technical reference covering How to connect a Layer 3 switch to a gateway. Review network topology, split ratio, box or cabinet capacity, joint closure rating and loss budget against current project documentation.

ODN and passive infrastructure knowledge brief Published 19 Jan 2023

Prepared for preliminary research by the GESTIONVAL ODN knowledge desk. Confirm network topology, split ratio, box or cabinet capacity, joint closure rating and loss budget against current standards and product documentation.

How to connect a Layer 3 switch to a gateway

Configuring Layer 3 Interfaces

All Ethernet ports are switched interfaces by default. You can change this default behavior with the CLI setup script or through the

Related Video Reference

This video was associated with the source search result. Verify technical details against current product documentation and project requirements.

Technical note

This reference is intended for preliminary ODN and passive infrastructure research. Topology, split ratio, box or cabinet capacity, closure rating, cable type, test limits and applicable standards must be verified for the specific project.

ODN and Passive Infrastructure Updates

Still Have a Technical Question?

Use the inquiry form to describe an ODN network, passive component or distribution box question.

Start an Inquiry